01
Case at a glance
| Customer | 18,000 m² distribution warehouse with offices |
|---|---|
| Scope | Warehouse and office floors · the same opening hours before and after |
| Applied | 420 HB-150 LED high-bay lights · EC-90 fans in 2 air handling units · BC-2 controls |
| Measured | 12 months before and 12 months after · site electricity meter · weather-adjusted |
02
Lights and fans ran at full power all day
The warehouse lights were metal halide fixtures, left on from 6:00 to 22:00, even in aisles nobody used for hours.
Both air handling units ran at a fixed speed around the clock, so they drew the same power at night as during the busiest shift.
03
LED lights with sensors and fans that follow demand
We replaced 420 warehouse fixtures with HB-150 LED high-bay lights. Each one dims to 20% when its motion sensor sees no one for 10 minutes.
We fitted EC-90 fans to both air handling units, and BC-2 controls now set fan speed from CO2 and temperature readings instead of running at full speed.
The work was done at night over five weeks, so the warehouse kept shipping.
04
What changed
Lower electricity use
Annual electricity use fell from 1,480 MWh to 1,010 MWh, from the site meter and adjusted for weather.
Light only where people work
Aisle lights spend most of the night at 20%, and the shift lead sees lighting by zone on one screen.
Fans that follow demand
Fan speed now follows CO2 and temperature, and the units run at 40–70% speed for most of the day.
Measured at the site meter
1,480
electricity use in the 12 months before
1,010
electricity use in the 12 months after (weather-adjusted)
32%
lower annual electricity use
05
Used at this site
Product 01
HB-150 LED high-bay light
A 150 W LED high-bay light with a built-in motion sensor and dimming.
- 150 W
- Dims to 20%
- Mounting height 6–14 m
Product 02
EC-90 fan retrofit kit
Replaces fixed-speed fans in existing air handling units with EC fans that change speed.
- Fits existing units
- Speed 20–100%
- Night install
Product 03
BC-2 building controls
Sets fan speed and light levels from sensor readings and shows energy use by zone.
- CO2 · temperature · motion
- Energy use by zone
- Monthly report
06
Questions about this case
01How did you measure the savings?
We compared 12 months of site meter readings before and after the work, adjusted for outdoor temperature.
02Will our building save the same amount?
It depends on your equipment, opening hours, and climate. We log your lighting and fan use for four weeks first and estimate the savings from that.
Energy projects desk
- energy@example.com
- Phone
- +1 555 0188
- Hours
- Mon–Fri 8:30–17:30